I tried all 68 links that come up at the link, none produce an image. I also tried most of the links separatly in Icamsource with and without a user name and pasword:
http://user:password@ipaddress:port#/insert_mjpeg_url_here. I have also tried links with a channel designation as "1" and I also tried it with a "2" as the MJPEG is the substream. The main channel is H.264 and cannot be changed. I have also tried video url's that I found on the web for Hikvision IP cameras as the Trendnet camera is a rebranded Hikvision DS-2CD2012-I. They look exactly alike and the specs appear to be the same.
I have found that if I don't use the user and password in the beginning of the url, I get the error that the camera cannot be found. I'm at work right now and can't try it to get the exact wording. If I use the user:password and hit start, for most attemps, it doesn't error, but does not produce an image.
I opened a help desk ticket with Trendnet and their suggested url was:
http://ipaddress/Streaming/Channels/1/httpPreview. I had already tried this one with channel 1 and 2 and with and without the user and password in the url and it did not work in Icamsource.
I'm beginning to think that this camera is not compatable with Icamsource, even though it is MJPEG compatable. Here is a list of url's that I made from searching the web and have tried. Some are repeats of the ones from the mjpeg_test link.
Trendnet mjpeg video urls to try with icamsource
http://xx.xx.xx.xx/IMAGE.JPG (for single JPEG images)
http://xx.xx.xx.xx/VIDEO.CGI (for streaming MJPEG video)
http://192.168.5.21/cgi/jpg/image.cgihttp://192.168.5.21/cgi/mjpg/mjpg.cgihttp://user:password@192.168.5.21/cgi/mjpg/mjpg.cgihttp://user:password@192.168.5.21/cgi/jpg/image.cgihttp://xx.xx.xx.xx/goform/capture (for single JPEG images)
http://xx.xx.xx.xx/goform/capture/video.cgi (for streaming MJPEG video)
http://xx.xx.xx.xx/goform/video (for single JPEG images)
http://xx.xx.xx.xx/goform/video2 (for single JPEG images)
http://xx.xx.xx.xx/cgi/mjpg/mjpeg.cgi (for streaming MJPEG video)
http://user:password@xx.xx.xx.xx/Streaming/Channels/1/httppreview (MJPEG)
http://xx.xx.xx.xx/image/jpeg.cgi (for single JPEG images)
http://xx.xx.xx.xx/video/mjpg.cgi (for streaming MJPEG)
You will need to disable "User Access Control" of the camera via the web configuration interface (see manual). Apparently, Motion does not work when authentication is required when accessing the URLs. Don't worry as user access control is a separate matter from the "admin password" of the camera. The admin password is only needed when changing camera settings.
rtsp://IPADDRESS:554//Streaming/Channels/1
http://IPADDRESS:554/cgi/mjpg/mjpeg.cgihttp://IPADDRESS/cgi-bin/video.jpgThanks,
Bob