Messages

1

iCam Support / Re: Possible AT&T 3G Changes Coming for iOS Devices Running iCam?

« on: May 20, 2011, 11:52:47 AM »

Per your request:
Check "Auto-Config Router" and Start.
Note UPnP Success 12000->12000
Stop iCamSource
Port Checker reports 12000 BLOCKED.

Comment: I have not changed any router configuration for years.
Can my Internet provider or AT&T change settings on my router? I don't think so.
The only thing I see that changed in the past few months (when I started getting "Connection Error" via 3G) is AT&T's service in my area.

2

iCam Support / Re: Possible AT&T 3G Changes Coming for iOS Devices Running iCam?

« on: May 08, 2011, 02:13:53 PM »

When Auto Config Router checked, message is: Connected to Server UPnP Success 12000->12000
I still get Source Connection Error on iPhone using WiFi.
Even with Firewall turned off.
Mac OS X Version 10.6.7
SIEMENS Gigaset SE567

3

iCam Support / Re: Possible AT&T 3G Changes Coming for iOS Devices Running iCam?

« on: May 04, 2011, 03:18:54 PM »

I have tried checking the "Auto-Config Router" checkbox and restarted.
After that,
I still could not connect via AT&T 3G
And then, I  could not connect via my Wi-Fi also.
So I unchecked that checkbox and was able to reconnect via Wi-Fi again but still not AT&T 3G.

4

iCam Support / Re: Possible AT&T 3G Changes Coming for iOS Devices Running iCam?

« on: May 04, 2011, 08:36:33 AM »

Up until about 2 weeks ago, my iPhone connected to iCamSource via AT&T 3G no problems.
Now I get the "Source Connection Error ..."
Depending on my location, whatismyipaddress starts with the following:
198 Romney, WV
198 Pikesville, MD