Show Posts
1
iCam Support / Re: Troubleshooting 103 - Port Forwarding
« on: August 04, 2010, 08:13:38 AM »
Hi there,
First of all i'm just a novice when it comes port forwarding.
I currently reading previous notes from this forum but I think I'm a little bit lost.
I currently got Iphone 3gs, I could connect through wifi , but not through 3g.
I've currently re-installed icamsource beta, and selected auto config for port.
After selecting auto config, I, ve got the message upnp successful 12000-12000
but when i try to check the port through port checker: status not open or unreacheable.
I've check the setting of my Sagem router, went to settings, and added service udp 12000-12100
but i cant still acces icam through 3g.
Thank you so much in advance
First of all i'm just a novice when it comes port forwarding.
I currently reading previous notes from this forum but I think I'm a little bit lost.
I currently got Iphone 3gs, I could connect through wifi , but not through 3g.
I've currently re-installed icamsource beta, and selected auto config for port.
After selecting auto config, I, ve got the message upnp successful 12000-12000
but when i try to check the port through port checker: status not open or unreacheable.
I've check the setting of my Sagem router, went to settings, and added service udp 12000-12100
but i cant still acces icam through 3g.
Thank you so much in advance