Author Topic: icamsource not respecting disabled detection zones  (Read 767 times)

vthyng

  • Newbie
  • *
  • Posts: 1
    • View Profile
icamsource not respecting disabled detection zones
« on: January 05, 2016, 11:57:47 PM »
I had v2.7 installed before I upgraded to Windows 10 and it was working fine.  I started using 2.7 again recently after installing a new camera and had motion detection zones working well.  icamsource was crashing more than I recall, so I thought I should upgrade to 2.8.2.  Now the detection zone is not respected at all.  In fact I disabled the entire grid and it still detects any movement!  I also tested enabling all zones and that of course worked too.  Is there something I need to reset because I upgraded from an older version?