To see your network cameras, you should be using iCam Pro Source on your computer & iCam Pro on your iPhone. ICam Pro (Mobile), is for using your iPhone as a "source" camera to broadcast to other iOS devices.
Thank you for your continued efforts! I excitedly downloaded & installed the new build (1.3.1.1a). I received TWO motion alerts on my watch with images; but have NOT received any alerts since.
I DO receive motion alerts on my iPhone 11, and iPad & can see my camera on both those devices.
On iCamSource Pro (on windows 10) PC preview I see iCamSource Pro 1.3.1.1a, Connected to Server. HOWEVER, the preview window (camera tab) is grayed out (no camera view). IF, I move my cursor to any other TAB (detection, etc) I immediately get a NOT RESPONDING message, instead of Connected to Server.
Addendum: This morning (0700 est), I am again receiving motion alerts on my watch & even though iCamSource Pro indicates Connected to Server (Not Responding), I am able to see my camera on iPhone & iPad.
Thanks Stefan! No "preview." I receive a notification "Motion Detected Camera X." If I take no action (tapping Watch notification) it goes away; but I get the Red Dot to tell me (remind) I have a notification. When I swipe the Watch, I see the notification "Motion Detected Camera X." If I tap that notification, the watch would indicate "Loading Thumbs." I could then select a thumb to see what was detected.'Now however, the display only shows the word "Loading," then changes to "No Camera Alerts." I know this is a confusing issue for us both. Here's another one: My iPhone Bluetooth indicates it is connected to my Watch; Bluetooth on my Watch indicates it is Searching for devices (never locking in on the iPhone or anything else).
I receive notification of say: Motion Detected on Carport. When I tap that alert: I receive "Loading (blank); used to say "Loading Thumb(s). Then it changes to "No Camera Alerts"
I know there are at least three (my notification threshold).
It would be easier (at this point), to have the Apple Watch say "motion detected on camera x" go to your devices to see what was recorded."
I had NOT removed iCamPro from my Apple Watch; however, it has been reinstalled now! I also reinstalled iCamPro on my iPhone.
Still have the same issue!
I do now receive an iCamPro Source Connection Error. My currently ONE camera, shows in the iCamSource Pro preview window on PC, in iCamPro on my iPad and iPhone.
I started receiving Camera Alerts on my Apple Watch. What I receive in sequence is: No Camera Alerts...Loading Camera...No Camera Alerts. My iCamSourcePro Version is 1.3.1.1 (Windows 10) with Notification Threshold of 3, Record Minumum of 2. iPhone 6 Plus, iOS 12.4 - Watch OS 5.3
It appears the loss of images (thumbs) occurred after the Watch OS 5.3 upgrade?
Using the "normal" URL for my Wansview P2P, it showed in the preview window nicely at first. After about 3 minutes, I received a 400 Error, and have not been to load the camera after that. In other words, I now receive the 400 Error immediately. LQQKIng forward to the Windows version!!
Show Posts