Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Vanduin

Pages: [1]
1
Same problem in Sierra. Did you ever get an answer to this?

2
iCam Support / Re: Troubleshooting 103 - Port Forwarding
« on: January 21, 2017, 08:15:27 PM »
Hi!

In earlier versions of iCamsource it was possible to add two fields to define the port forwarding range via the terminal with this command:

defaults write com.skjm.icamsource PortRangeSet -bool true

If I try that with 2.8.5 on Sierra there are no fields added to define the port range.  :(

How can I enable the two fields to define the port range?

Thanks!

Pages: [1]