Show Posts
1
iCam Pro Support / 2nd camera / Logitech
« on: August 07, 2016, 03:59:11 PM »
So i installed server pro, i was running a cheap HP-2200 camera as a single camera. Everything runs FINE.
I go buy a Logitech C-270 camera as a second camera, Everything runs FINE.
I am running dual camera just FINE for days! Had ports forwarded properly, everything was running SMOOTHLY, i could see both cameras on my Android phone, manage all the settings, motion detection, view recorded images etc etc...
Everything was running smoothly for days.
Then, my computer froze, i had to hard reboot. Ever since then i have a problem streaming the Logitech Camera. The server software detects the camera, i can manage it with the server software on the desktop, but when i boot up the Android software on my phone, all i see is the HP camera, it wont show me the Logitech camera. After a few minutes of this, the server software then gives me an error and i have to shut it down and restart it.
If i run the server software with just the ONE HP camera, no second camera listed, it runs just fine, forever. If i add the Logitech camera as a second camera, OR EVEN IF i remove the HP camera and make the Logitech camera the only camera, i get the same problem. The server shows the camera just fine, i can see myself in it on the screen, but it wont show it in on my android phone. And again, if the Logitech camera is in the server (as a second camera, or only camera) the server software will crash after a few minutes.
I have tried rebooting, restarting router, modems computer, i even uninstalled the program and reinstalled it. I have no other camera software running (this is a bare bones cheap "server" computer i leave on 100% that i only run uTorrent, Plex, and now iCam Pro on).
What confuses me is that for a few days when i first bought the Logitech camera as a second camera, it ran just FINE for days. Then all of a sudden, i cant get it to stream/feed the Logitech feed to my android phone!
Any thoughts?
I go buy a Logitech C-270 camera as a second camera, Everything runs FINE.
I am running dual camera just FINE for days! Had ports forwarded properly, everything was running SMOOTHLY, i could see both cameras on my Android phone, manage all the settings, motion detection, view recorded images etc etc...
Everything was running smoothly for days.
Then, my computer froze, i had to hard reboot. Ever since then i have a problem streaming the Logitech Camera. The server software detects the camera, i can manage it with the server software on the desktop, but when i boot up the Android software on my phone, all i see is the HP camera, it wont show me the Logitech camera. After a few minutes of this, the server software then gives me an error and i have to shut it down and restart it.
If i run the server software with just the ONE HP camera, no second camera listed, it runs just fine, forever. If i add the Logitech camera as a second camera, OR EVEN IF i remove the HP camera and make the Logitech camera the only camera, i get the same problem. The server shows the camera just fine, i can see myself in it on the screen, but it wont show it in on my android phone. And again, if the Logitech camera is in the server (as a second camera, or only camera) the server software will crash after a few minutes.
I have tried rebooting, restarting router, modems computer, i even uninstalled the program and reinstalled it. I have no other camera software running (this is a bare bones cheap "server" computer i leave on 100% that i only run uTorrent, Plex, and now iCam Pro on).
What confuses me is that for a few days when i first bought the Logitech camera as a second camera, it ran just FINE for days. Then all of a sudden, i cant get it to stream/feed the Logitech feed to my android phone!
Any thoughts?