Messages

1

iCam Support / Re: Supported Pan-Tilt USB Webcams and Network IP Cameras

« on: October 29, 2011, 11:17:35 AM »

I have a Tenvis cam and could not get the Pan-Tilt to work with the URL that gets suggested from the help page.  I was reading the help here and thought I would try FOSCAM since it was approved and used the video.cgi extension that was suggested and it worked!  I now have the pan tilt working great - thanks for adding this feature.
 

2

iCam Support / Re: iCam Source and Ubuntu

« on: July 29, 2011, 06:52:07 AM »

definitely -add another person to the list

3

Network / IP Camera Compatibility / Re: iCam and Axis 240 camera server

« on: July 12, 2011, 09:38:48 PM »

Fantastic. Thank you very much, I will give that a try.

4

Network / IP Camera Compatibility / iCam and Axis 240 camera server

« on: July 08, 2011, 08:13:17 AM »

I have three USB based web cams working great...love this product!!!   I recently got an older model Axis 240 camera server and have it set up.  I can see the output on the internal website so I know the camera is working, but when I used the iCam utility to put in the the full IP address I don't see anything and I get this message: 

"Your network IP cameral could not be connected to. Please make sure that the camera URL contains the correct network address for your camera"

This is what I entered based on the Help interface:
http://server ip address inserted here/axis-cgi/mjpg/video.cgi

Not very familiar with IP cameras, and not sure if this one is supported.  I have the camera connected via the s-video connection.

Any help is appreciated.  Thanks,

Mike