Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Wally

Pages: [1]
1
iCam Support / can't access my cameras after switching to google fiber
« on: October 22, 2015, 10:16:36 PM »
I got google fiber yesterday. Now I can't access my camera when I am away from my home network. When I AM on my home network, my iPhone accesses my two sources just fine. I still have my old AT&T DSL if you have any side-by-side test suggestions.

2
iCam Support / iCAMSource 2.1 crashes on my iMac !!!
« on: September 19, 2010, 11:31:53 AM »
Hi all -

ever since I updated, iCAMSource has been NOT running when I come home after a spell. Further, lately, it locks up my whole computer causing me to hard crash/restart !!! Unacceptable. Any ideas anyone? As I type this, I wonder if it does not know how to elegantly handle a stored files limit... I will investigate this and get back to you all..

- Wally

3
When I start iCAMSource, I do not see the icon in the task bar. I don't even know how to quit it. I <command><tab> to switch applications, and it does not appear in that list either.

Over the past two weeks while I was out of town, it ran for a few days, and then I could not connect to it for the past 10 days or so. The computer was not set to stay awake, so why did it run for 5 days, even if the computer was allowed to go to sleep? When I got back home, it iCamSource shut down each time the computer slept, OK, but where is it? How come I cannot see it when it is running?

Currently, it is nowhere to be found, though I double-clicked on the icon. I saw that some new version was available (for the iPhone) on this forum, and there was a link to a different version of iCAMSource? I downloaded that and ran it, and it did not "appear" either.

I reset the video converter for my camera (which I sometimes have to do - it converts video into Firewire) and then ran the iPhone app again, and apparently, both iCAMSource apps where running concurrently, because TWO of the four windows on the iPhone had the source (same source, of course ;) ), then it immediately posted a communication error message or something like that.

I am now going to restart the machine and see what I can make happen.

I realize that there were some posts about trying to hide the iCAMSource from appearing and I have done nothing to try to set that up.

- Wally

4
iCam Support / iCam Web stalls streaming
« on: May 13, 2010, 08:14:28 PM »
Hi all -

I am using iCam Web and the stream stalls and I have to click on the "sharing" link and retype the two words that prove I am not a computer to get it to stream again... it runs just 20 seconds or so before it stalls again, every time..

any ideas?

Wally

Pages: [1]