Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - BV

Pages: [1]
1
iCam Pro Support / Re: Webcam Authorization Failure
« on: June 15, 2016, 10:15:32 PM »
I found the problem

Allow password type setting in the camera needs to be changed to unencrypted.


logging into the Axis 5414 camera, go to system options, security, then to the users page. near the bottom of the page there is a listing "HTTP/RTSP password setting" and allow password type.  the pulldown gives three settings; encrypted/unencrypted---encrypted---unencrypted.   Default setting is encrypted/unencrypted and this will not work.  When changed to unencrypted, all of the URL's listed in the utility link you gave me worked.

thank you for the support

BV

2
iCam Pro Support / Re: Webcam Authorization Failure
« on: June 14, 2016, 10:05:55 PM »
Thank you for the reply,

Using your utility, there were 4 different URL's that delivered images.  This camera requires a password, I tried all of them with username and password before the camera address "H-t-t-p://LOGIN:PASSWORD@10.0.1.15:80/mjpg/video.mjpg".  Also, tried these URL strings with the user name and password and the end of the URL string as described in my first post.  I still get a 401 error in all cases.

The camera output is MJPG format data

3
iCam Pro Support / Webcam Authorization Failure
« on: June 11, 2016, 10:55:17 AM »
Newbie here,

I have an Axis 5414 PTZ cam that I get a  "401 Webcam Authorization Failure when I try to activate the cam in the normal manner"  I read the thread from SEV about the Foscam problem after a firmware update and tried that solution below:

"It looks like the new firmware will support the following MJPEG URL that is compatible with the iCamSource: "h-t-t-p://IP:PORT/videostream.cgi?user=USERNAME&pwd=PASSWORD"

I can type in this URL string into my browser and iPhone and I get the camera image with no problem.  When I type in the same string into IcamSource pro "Mac OS" I still get the 401 error.

I understand the PTZ function might not work, I just want the video.

can you help

Pages: [1]