Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - inetdavid

Pages: [1]
1
Beta Testing / Re: iCamSource 2.3 BETA - Motion Detection Zones
« on: July 09, 2011, 02:10:13 PM »
I'm currently running iCamSource 2.3.1 BETA and the USB DYNEX Webcam on my Mac Pro works great, but I'm unable to get an Ethernet / Wi-Fi connection to an older D-Link DCS-900W to work.

Using your URL helper page I was able to determine that the following two URL's work fine from Safari for JPGs or MPGs:

http://192.168.0.20/IMAGE.jpg
http://192.168.0.20/VIDEO.cgi

But those same URLs fail to make a connection from iCamSource on the same computer.  The DCS-900W does require me to add username and password, and I've filled out those fields in iCamSource multiple times, including using cut/paste once to make SURE the password is correct.

(5 minutes after posting: Of course, I try it ONE more time, and this time it connects.  It may have been a problem with me viewing it at the same time on the browser, causing a slow connect as this is an older, slower camera.  I.E., "Never Mind")

Pages: [1]