SKJM Forum

Support => iCam Pro Support => Topic started by: palmfox on June 13, 2014, 01:29:40 PM

Title: Pan/Tilt on iCam Pro
Post by: palmfox on June 13, 2014, 01:29:40 PM
Hi Stephen

Two of my cameras work fine for panning and tilting on the regular iCam, but do not work on the iCam Pro. I also noticed that iCam Pro defaults to snapshot.cgi even though the setting for iCam allows both camera's to use video.cgi. Could this be the problem? Everytime I try to swith to mpeg and get the ip address/video.cgi it automatically jumps it back to snapshot.cgi and jpeg.

Any ideas?

OK.. never mind.. I figured it out.. I can't run iCam and iCam Pro at the same time!..Turned the old off, and now it works!


Thanks